Machine Shops In Sacramento/Elk Grove Area
#1
Machine Shops In Sacramento/Elk Grove Area
Hey guys, I just got introduced to this forum (the NorCal Chapter) a few minutes ago. Wish I'd have looked around more before.
Anyway, hello everyone.
I have a 94 F350 CCLB with a 7.5L. It is looking like the head gasket on the driver side needs replacing, thus doing both for obvious reasons. What I would like to find out, is if there's a decent Machine shop somewhere either in Elk Grove South Sac area or even the Sacramento, Rancho Cordova, Folsom area. I work in Folsom, but live in Elk Grove. I drive down Grant Line every day so I can basically branch off into any part of town from there.
I would like to see about getting the heads reconditioned while I have them off. I just don't know the cost and if I have the budget for it or if I just fix the gaskets now and do that down the line. Would suck to have to pull it all off again, but if i don't have the money I don't have it.
Thanks everyone!
Anyway, hello everyone.
I have a 94 F350 CCLB with a 7.5L. It is looking like the head gasket on the driver side needs replacing, thus doing both for obvious reasons. What I would like to find out, is if there's a decent Machine shop somewhere either in Elk Grove South Sac area or even the Sacramento, Rancho Cordova, Folsom area. I work in Folsom, but live in Elk Grove. I drive down Grant Line every day so I can basically branch off into any part of town from there.
I would like to see about getting the heads reconditioned while I have them off. I just don't know the cost and if I have the budget for it or if I just fix the gaskets now and do that down the line. Would suck to have to pull it all off again, but if i don't have the money I don't have it.
Thanks everyone!
#2
Last place I used was Ron Gross in Galt in the late 90's-dont even know if they are around anymore to be honest, dont know quality since then either. someone will be along shortly for you
quite the write up in your signature-I got about half way through, I will finish the rest soon, thanks for posting
welcome to the nor cal chapter-great guys here
quite the write up in your signature-I got about half way through, I will finish the rest soon, thanks for posting
welcome to the nor cal chapter-great guys here
#3
Thread
Thread Starter
Forum
Replies
Last Post
jay54f100
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
4
06-24-2008 10:51 PM