Hey All:

I recently replaced Big Red '93 F250 7.3 NT Auto with Matilda '91 F250 7.3 NT 5Spd 4x4. I found Matilda's Flywheel cover under the truckbox, but I need the bolts to reattach the flywheel cover. I've tried RockAuto and JC Whitney -Any ideas?
Thanks!
Catdaddyyy

 

Hardware store. The shield isn't a critical piece so generic hardware can be used.

 

Thanks, UNTAMND! -Any idea what size bolts/screws to use, or should I just use trial and error? BTW: I just ordered Hayes' "Diesel Engine Repair Manual: General Motors and Ford V8 Diesel Engines"

 

No idea. Either 5/16 or 6mm I'm guessing. Could be 3/8 or 8mm though.
I'd think 5/16 because this era of ford used metric head, standard thread bolts.
Trial and error will work. Just make sure they aren't too long.

 

Thanks, UNTAMND -Have a good one.