Been away a few years
#1
Been away a few years
Hi guys and gals,
Getting back to work on my truck after a long break....putting my daughter through college...maybe now I can buy some more parts.
I am about to pull out the T-10 and install an AOD with a 10" converter and a TCI constant pressure valve. Also getting the track-lock rebuilt and adding some 4.56 gears.
Plans to change the dual exhaust to side exit so the spare can go where it belongs, lower the truck about 2" and give it a fresh paint job. Hope to be done by fall.
Thinking about removing the bumpers and making roll pans front and rear.
By the way I am in Rock Hill.
Getting back to work on my truck after a long break....putting my daughter through college...maybe now I can buy some more parts.
I am about to pull out the T-10 and install an AOD with a 10" converter and a TCI constant pressure valve. Also getting the track-lock rebuilt and adding some 4.56 gears.
Plans to change the dual exhaust to side exit so the spare can go where it belongs, lower the truck about 2" and give it a fresh paint job. Hope to be done by fall.
Thinking about removing the bumpers and making roll pans front and rear.
By the way I am in Rock Hill.
Thread
Thread Starter
Forum
Replies
Last Post
pipman76
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
06-25-2009 09:42 PM
FoMoColover
Clutch, Transmission, Differential, Axle & Transfer Case
7
10-05-2006 04:27 AM
kiksomepoo
Clutch, Transmission, Differential, Axle & Transfer Case
3
09-11-2002 02:14 PM