A previous owner of my regular cab 2002 4cyl. 2.3L automatic ranger cut the seat pretensioner wires for both the drivers side and passenger side. We have the connectors that come out of the floor of the cab, but not the connectors attached to the seats, just the bare wires. We have not been able to figure out how the wires match up because the colors are not the same. There are four wires on the driver's side and two wires on the passenger side. Any idea of where I could find the wiring diagram for the seats?

 

Looking over the '02 Manual, here's what I see:

Drivers side:
Pin 1 (BK) = Ground
Pin 2 (LG/BK) = Pretensioner Return to Restraints Control Module (RCM)
Pin 3 (BN/LB) = Seat Belt Buckle Switch to Generic Electronic Module (GEM)
Pin 4 (LG/RD) = Pretensioner Feed from RCM

Passenger Side:
Pin 1 = Not Used
Pin 2 (YE/BK) = Pretensioner Return to RCM
Pin 3 = Not Used
Pin 4 (YE/RD) = Pretensioner Feed from RCM