Replacing cylinder heads
#1
Replacing cylinder heads
Hi all,
I am getting ready to install a new set of cylinder heads on my 75 F250 Ranger 4X4 trucks 360 CI V8. The question I have is: in my Hanes manual it just states that I need to lightly oil the head bolts and proerly torque them to spec. Do I need to put any high temp gasket sealer on the head bolts since they go down into the water jacket?
Thanks, Pete
I am getting ready to install a new set of cylinder heads on my 75 F250 Ranger 4X4 trucks 360 CI V8. The question I have is: in my Hanes manual it just states that I need to lightly oil the head bolts and proerly torque them to spec. Do I need to put any high temp gasket sealer on the head bolts since they go down into the water jacket?
Thanks, Pete
Thread
Thread Starter
Forum
Replies
Last Post
my93
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
1
07-10-2012 07:53 AM
mongo75
1999 - 2003 7.3L Power Stroke Diesel
2
06-06-2011 07:08 PM
jamies460
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
5
06-19-2007 08:44 AM
bryan_johnson
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
5
04-20-2005 05:36 PM