K&N IAT grommet
#1
K&N IAT grommet
Hey guys...I was just finishing up on some intake manifold work last night, and while I was reconnecting all the hoses and connectors, I realized that my IAT sensor wouldn't stay in the hole. Upon further inspection, I noticed that the grommet had fallen off/out.
I'm wondering if anyone has a part number for the grommet from K&N, or a part number for a suitable substitute, and where to get either? I looked endlessly online, and all I could find was that I would need to purchase the entire system that I already have. I'm sure most of you are pretty ingenious, so if there is a 'home remedy' that some of you have used, I'd love to hear about those too.
Thanks! Cheers
I'm wondering if anyone has a part number for the grommet from K&N, or a part number for a suitable substitute, and where to get either? I looked endlessly online, and all I could find was that I would need to purchase the entire system that I already have. I'm sure most of you are pretty ingenious, so if there is a 'home remedy' that some of you have used, I'd love to hear about those too.
Thanks! Cheers
Thread
Thread Starter
Forum
Replies
Last Post
snaponprofile
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
25
05-23-2011 02:34 PM
jax1-2
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
3
06-25-2004 03:23 PM
dcdave
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
2
01-19-2004 06:40 PM
NoPushrods
1973 - 1979 F-100 & Larger F-Series Trucks
4
09-04-2001 05:35 AM