Used my pickup to feed this morning, so i was in 4lo and i noticed the 4x4 light was on, but not the 4lo light. However, when i was done, and put it in 2wd the 4x4 light is still on. Was driving down the hwy later and the low range light kinda flickers, comes on, flickers, goes out... Transfer case is in 2wd, i put the hubs in and there was no binding when turning.

 

Just a bad switch on the linkage. Will probably get better when it warms up.

 

I hope so, i hardly ever use 4x4. Is the switch internal or external?

 

It's external, but now I think it might be on the tcase instead on the linkage. It's easy enough to find when you look under there.

 

thanks, if it doesnt sort itself out after a while ill climb under there.