Where to Get Some Louvers Punched Into Sheet Metal Near Tulsa?...
I've got a plate of stainless steel that i'd like to get louvers punched into, then i'll polish it and use it on the front of my moto radiator. Anyone know where I can get some louvers punched near Tulsa?
Dave wasn't there but his son was--they don't do louver punching anymore. Hot Rod shop in Sand springs doesn't either. Some online hot rod forums mention 'Doc Parsons' of Tulsa, but no one says how to contact him.
I did find a site that showed someone making his own punch. I'll see if I can find it again.
I found one on the HAMB hot rod site. The guy used a couple plate steel pieces welded together and a grinder to get the rough punch shape. Then he shaped the female plate hole and cut the slots into the sheet steel to make punching easier. He used a big hammer to make the louver punches. I would use a shop press.
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.