Expedition Engine stalling

Reply Subscribe

Thread Tools

Search this Thread

09-02-2013, 10:51 AM

tomss

New User

Thread Starter

Join Date: Sep 2013

Posts: 2

Likes: 0

Received 0 Likes on 0 Posts

Expedition Engine stalling

Hello there,
I have 2010 Ford Expedition Max 4WD Eddie Bauer edition and I have currently 75,000km on it. I love this truck and it has been great. However, lately I experienced some problems. Truck is stalling when slowing down to a stop at lights. I need to shut the ignition off, wait few seconds and restart the truck. At first it was happening sporadically but over few weeks it become more frequent. I dropped my truck at the dealer and was told that the problem was faulty Throttle Position Sensor. it was replaced and it seemed to correct the problem. However, few weeks later similar problems started and quickly become more sever. Within a week my truck went into a "crawl' mode and I was not able to ref the engine above 1000rpm. I dropped it again at the dealer and was told that this time it was a gas pomp. It was replaced and the problem seemed to go away for a week or so. I am back at the same scenario that truck is stalling at every second light and this time a "check engine" warning light come up. Also, i noticed that when the car stalls there is a "burning" smell - like the engine is running super hot but the engine temperature indicate normal temperature.
I am a bit frustrated now. I wonder if anybody has similar problems and what was it cause by. I would appreciate any suggestions.
Thanks a lot.
Tom
<!--[if gte mso 10]> <style> /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority

9; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin-top:0cm; mso-para-margin-right:0cm; mso-para-margin-bottom:10.0pt; mso-para-margin-left:0cm; line-height:115%; mso-pagination:widow-orphan; font-size:11.0pt; font-family:"Calibri","sans-serif"; mso-ascii-font-family:Calibri; mso-ascii-theme-font:minor-latin; mso-fareast-font-family:"Times New Roman"; mso-fareast-theme-font:minor-fareast; mso-hansi-font-family:Calibri; mso-hansi-theme-font:minor-latin;} </style> <![endif]-->

Reply Like

09-03-2013, 11:26 AM

FordServiceCA

Official Ford Rep

Join Date: Jul 2013

Posts: 157

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by tomss

Hi Tom,

Have you been back to the dealer since the concerns resurfaced? Please PM me your VIN; I'll see what I can do.

Bianca

Reply Like

09-03-2013, 07:02 PM

wadesdad

New User

Join Date: Sep 2013

Posts: 5

Likes: 0

Received 0 Likes on 0 Posts

Stalling

Take a look at your Fuel Pump Driver Module. I am not certain where they put them on the 2010, But it should be on the rear frame rail either just behind the rear driver's side tire, or just in front of the spare tire on a frame rail there. It is about 4.5" x 4.5" black box with lots of wires and just 1 connector. When they fail, they "cook" and smell bad. They vary voltage to the fuel pump. My wife's failed on her 06 Navigator. It was an easy inexpensive fix $135 from NAPA.

Reply Like