A 1973 F250 4x4 converting to power steering and electronic ignition. Need a wiring harness that's set up for the Brain box. A complete harness would be nice but min. under the dash at the fire wall. Harness.
I need a COMPLETE WIRING harness for a 74 to 78 f250 with the Ignition Control Module. Something that's not spliced and diced. I am disabled looking for some help finishing my Ride. I am on a fixed income looking to get my truck fixed RIGHT, e-mail me. I can't get to the messages here. I don't know why. The harness has to have no splicing or hacked upon issues. It needs to be for a Dual Fuel Tank assembly. with the Primary at the Rear.
looking for back side windows that open for a supercab, chrome drip rail trim, wide chrome trim that goes in the dent supercab specific, and the piece of racetrack trim for supercab specific... Also looking for complete locking hood latch, and A bedside toolbox section...
Fords - 1978 2wd F100, 1978 F250 Supercab 4x4, 1978 F150 shortbed 4x4 32k origanal miles, 2x 1978 Bronco - Toyotas - Forum Profile - 1987 4wd 22RE (Yeehaw), 1989 4wd SAS 20R - Chevys - 1958 Apache - (Drag Racing Vehicles) 1987 355 V8 S10 with a powerglide... West Virginia Chapter Member!!
i may have a harness but need to check for cut wires and you know the columns use a differant system in 78/79.. plus the distibuter and the igniyion switch is differant.. as for yje steering box the highboys used s very sophisticated overly engeniered and now obsolite power assist system.. cant help with that unless you do the 78/79 conversion..
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.