Hands down the winner! That's awesome!

 

Did you do a write up or follow a guide? My brother is wanting to do this with his 2wd SD.

 

Left mine at home parked today.

 

Saturday used it to get the 86 F150 out of the mud and get home safely as the windshield wipers failed. The 86 was hooked up to the 275 gallon water trailer and had sunk in the mud 3 inchs in the front and 4-6 in the rear and trailer.






Then this morning my dad brought the 02 in to town and some idiot in a 90s chevy cut my dad off my dad didn't have enough time to stop completely and smashed the front liscence plate bracket no other damage so I fixed that this morning luckly wasn't to bad.
Trav

 

I started a thread for it with a parts list including all part numbers and prices. I still have to finish updating it and putting together the walk through. Hoping to get it all updated by this weekend.

 

I haven't done it yet, but I am going to install it this afternoon. I bought a Kobalt 56 inch aluminum toolbox for the F350 flatbed. Here it is. Will post pics today after the install.

 

Today I installed the Kobalt tool box and some humor on the Mulehauler....

 

Bought mine a set of Bilstein's 5100 series, replaced the Rancho's don't know what series, but one of the was 100% gone when checked. Good ride, coming back from McAllen to Houston.

 

Had 4 new BFG TA KO's put on Friday!!! Will post pics if the weather cooperates and I can get the truck washed. Hate that Blue crap on the white letters!!! Unfortunately an inch and a half of rain fell today!!!

 

Burned $20 of gas to go 40 miles... Not a good daily driver. Haha, but loved every mile of it.

V10, 4.30, 4x4, dually, cc, Lwb...

 

Installed a new performance tune from 5startuning on my 99 v10...

Hit a double down shift and the chip made the higher rpm go from pretty boring to pretty good = BSEG.

The bottom end torque is still great too.