ScanGauge stop working......
#1
ScanGauge stop working......
My ScanGauge by AreoForce is not working after I replaced my GPR.
I disconnected both ground to the batteries, replaced the GPR, tested the GPR with a multi-meter and all tested good.
I start my truck and now the ScanGauge will start up and only show the FORD POWERSTROKE and the AREOFORCE screens then it will shut off. over and over again.
I triple check the power supply to the gauge and all looks to be good.
Any ideal what would cause my gauge to stop working ?
I disconnected both ground to the batteries, replaced the GPR, tested the GPR with a multi-meter and all tested good.
I start my truck and now the ScanGauge will start up and only show the FORD POWERSTROKE and the AREOFORCE screens then it will shut off. over and over again.
I triple check the power supply to the gauge and all looks to be good.
Any ideal what would cause my gauge to stop working ?
Thread
Thread Starter
Forum
Replies
Last Post
maevans
1999 - 2003 7.3L Power Stroke Diesel
21
04-28-2014 06:06 PM
yukonsly
1994.5 - 1997 7.3L Power Stroke Diesel
12
04-28-2007 08:22 PM