Category: Exterior - Body Parts
Price: $1
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): CRX & pre '92 Civic
Item Condition: CA
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck, Part suitable for diesel truck

Hi, I have a 49 we are restoring. Need a good driver door, running boards, that piece under grill between fenders. Probably a bunch more but that is the obvious. Going to repait the fenders I think. Do you still have a set of front fenders in good shape? how much. jwalk@usd-llc.com. Thanks, Jeff

 

I should have the spring, but need to check.

 

I have a pair of doors from a 51 deluxe cab truck. They're slightly different on the inside.

I have the lower valance between the fenders and two pairs of solid F1 running boards.

I sold the front clip that was in the better condition.

I will email you the pictures within the next few days.

 

do you have anything in the way of fenders for a 1956 f600 need both if not could you give me some info where I might find some

 

PanelMan -

Do you have any more vent window frames for a 1950 F-1?

thanks

 

How much for running boards for a 52 F1?

 

Do you have the bushings for 1951 F1 running boards to front fenders?

 

Do you have front fender extensions for a 1950 f1?

 

Hi, Im looking for 2 front fenders, and 2 full running boards shipped to either 28532 or 48035. do you have any and if so, how much? can you shoot me a pm

 

51PanelMan,

I am looking for some hood trim for a 1950 F1. I have the handle for opening the hood and I have the dummy handle on the right opening. I also have the curved piece for each side where the handles are, but I am missing the short vertical piece of trim that connects the top and bottom of the curved pieces. Do you have this piece for each side?

Thanks.

 

Do you still have the front fenders? I am looking, and ready to buy. Please let me know. Thanks.

 

Currently, I do not have anything that is in decent condition.

$300 for a pair, plus about $80 to ship. PM or email if you're interested.

Pictures: 48-52 F1 Running Boards Set 3 Photos by modelking1 | Photobucket and
48-52 F1 Running Boards Set 2 Photos by modelking1 | Photobucket

Not sure what you mean by "bushings".

I do. However, I have several people interested in complete fenders (uppers/lowers).

I sent you an email.

You only need the vertical piece for the hood latch handle side only as the dummy handle has this vertical pieces already molded in with the handle. I have a few of the vertical pieces to select from. PM sent.

Contact has been initiated.

 

Hi have a 48 f1 and looking for a bench seat with tracks if you have one

 

Hi Panelman,

I am looking for the Ford emblems on the side to the hood for a 48 F3. Also the radiator splash pan (not sure the name) that sits behind the radiator at the bottom. Also remember you had F2 rear axles. I need the backing plates, drums and complete brakes to convert my F3 to a F2 rear so it will be easier to get parts. Right now there are no brake shoes and they are hard to find.

 

I have everything to set you up. However, I can't PM or email you through FTE because you don't have those options set. Please email me directly at modelking2000 at hotmail dot com and I'll provide you with my phone number to make the discussion easier.

Thanks.