Haven't been on here in a while due to life in general haven't even had time to work on my old girl... here is a long story short....

After around 6-7 months of fighting with the trucks master cylinder for the clutch it won't keep them long enough to even be able to drive the truck out of the driveway... i drove the truck a few times floating it cuz at that time it was my only mode of transportation... i pulled into the driveway... my idiot self didn't take it out of gear before shutting the truck off... and the truck paused like it was gonna stop then rolled to a stop i found that i snapped the center piece out of my clutch... that was 2 months ago... i haven't had time for the old girl since... except enough time to pull the trans out and switch to an old clutch plate that a friend of mine had..(still a good plate though)... now by myself i can't get the transmission back in the truck... got a buddy coming over tonight... to help me get it in... i have one battery fully charged and the other one is an over sized battery in my car...(its really funny to be honest) anyway i am gonna put it back in and figure out why my electric pump is not kicking in through the wire its hooked up too... (but is kicking on when hooked to a pos. wire from the battery) other than that is there any suggestions on helping keeping me from putting extra strain on anything since the truck has sat for about 2 months?.... (glow plugs are now good) so it will be plugged in...

by the way hope everyone is good haven't had time to see everyones stuff yet

 

Good luck with it

 

Make sure you do the tranny before BEER!