okay guys i need something and i need it fast i need the tail light wiring harness. was working on mine today and figured out why my lights dont like to work too much. my harness is screwed it has had so much water and what not that it all corroded and fell apart to the point that i got pulled over and got a ticket because my lights were completely blacked out
so if any of you have one or an extra one PLEASE PM ME

 

bummer.well,hard to blame him for just writing ya up because that one is real dangerous.if you had one side working back there he should have been a little kind and just warned ya lol.if both were out,well.....yikes lol.

Dorman 85872 i think is what you need.around 6 bucks at auto zone.they might need to ship it in overnight. can't tell where ya are in your profile,but if no AZ's im sure most auto parts would get it right in if not in stock.
of course a junk yard might just let ya snip one out for nothing or a buck or so too.

 

Is that doorman part the entire wire harness for the tail lights cause that's what I need is the one that plugs to stock harness lol
As far as getting pulled over it was a hwy patrol and he only gave me a fix it ticket so I git it fixed and now I just need to get an officer to sign off on it and he pulled me over right after I left orielly so yea I was headed for the back streets

 

okay thats just the socket peice for the light bulbs and thats not what i need i need the entire wire harness for the tail light section. it unplugs just at the rear of the bed and then runs to the tail lights and license plate lights

 

You might try Rock Auto, I seem to recall seeing wire harness there.

 

checked rock auto. nothing as far as a wiring harness for the tail lights in there

 

Buy a roll or rolls of wire and run all new from the pigtail....

 

that is what i would do. brown for turn signals, green, and yellow for blinkers, black for ground, and another wire for reverse lights.
using these colors will make it easy, because they are the universal colors for rear lights.
get a few new pigtails to go in the light, and make your own harness.
should only cost you around $10 and an hour to do.

 

I did that already I just cut the wires from the one end of the pig tail and put spade connections on it and then plugged it back in the other end but I was hoping to get a new harness so I could have my trailer plug still.

I think its BS that not even lmc makes a harness for these things and our only hope is to find another from a JY that's gonna soon give out like this one did