ignition control module from a 78 302 on a59
#1
#3
#7
Sorry for the late response I've been out of town.
Is this the diagram you are looking at? I'am color blind but if I read it correctly the green wire goes to the coil. If pressed you could just cut and splice the wires from the controller and run them to where ever they need to go.
But then again you have probably got the truck running by now.LOL
Good luck in your quest!
Is this the diagram you are looking at? I'am color blind but if I read it correctly the green wire goes to the coil. If pressed you could just cut and splice the wires from the controller and run them to where ever they need to go.
But then again you have probably got the truck running by now.LOL
Good luck in your quest!
Thread
Thread Starter
Forum
Replies
Last Post
donatorc
Performance & General Engine Building
3
08-19-2010 06:36 PM
wolverineflight31
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
2
08-04-2003 09:58 PM