I have an 08 F350 SRW Job 3 I Installed a S&B Air Box this morning. I took the truck for a run and all seemed well. Later went for run and got a wrench light. Both the OEM tranny temp gauge and the MinMax tranny guage showed zero and the fan engaged. Checked for codes and got P0710 and P0713 codes - both relating to tranny temp sensors. Could this be, in any way, related to the S&B install? Seems weird it would happen shortly after the install. Temps here are mid 70s right now. Historically my tranny temps have been 165 to 175. I drive like the grandpa I am with little to no hard acceleration.

 

since the airbox is right there with the wiring harness connections maybe you bumped it and it has lost the signal?

Just for kicks I think I would take the one on the right as you are looking at them off. Check all the pins and try again.

 

Got the truck back from Ford yesterday. It was the sensor and changed under warranty. Had a tranny flush done while they had the pan off.

 

Great end result. Kill two birds with one stone.