Hunting, long distance driving at at 100 + mph, and never forgetting the young jive *** kid in daddys BMW, who thinks he's the Carl Edwards of the highway, that needs to get his chemical imbalance set straight.
Would really like to hear yours, and other experts opinions of Scat making cutom H-Beam Rods............? All the Carillo, Crower etc., run around $3000. Scat may well get them done for under $1000 per set.
Only thing is, the minimum order is 6 sets, + 2. I am willing to try but I can't order 6 sets.
I know your building the ultimate brag wagon... but for the rods... you could stuff stocker forged rods back in and be straight. I wouldnt bother with all the super fancy custom rods unless your looking to make rediculous horsepower that will just sling mud and bury axles.
For your application... there is such a thing as too much.
Make your target horsepower around 450 and you will be incredibly pleased with the rigs power capabilities.
Think power to weight ratio...
The trucks these motors usually power weigh in at 8k minimum... up to near 12k like motorbug.
Just a couple pennies from a fool...
Keep em... or leave em in the change tray.
Motorbug:2000 F350 Lariat CC,LB,6x6 7.3DIT,4" Turbo-Back, IH Bellowed Uppies, RiffRaff FRx&AIH Delete, Hutch/Harpoon,6637, 05-07facelift, dual cowl induction hood, Glowshift Max Tow gauges, antique BullyDog 1 Toon chip, 10k, Air Lift on rear axle, All the hitches!
420k & counting AE Total Ford Enhanced Bundle
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Fordģ is a registered trademark of the Ford Motor Company.