Hi all, I have been searching through the old posts and was unable to answer my question. Is their a header like mustang type shortys that would most likley fit my application of a 351w with mustang ii ifs. Or even close to my application or will i need to custom make these.I would prefer stainless steel.

thanks sean

 

Sanderson has some block huggers that will prolly work for ya. Not cheap however.

 

SUM-G9063-1 Summit these are cermaic coated they fit I have 48 with tci mustang II front end with 351W you need to use small starter with a rear sump would post pic but have things apart at this time