300-6 blueprints?
#1
300-6 blueprints?
I am guessing these are not available anywhere (I searched a little bit) but I am trying to find blueprints on a 300.
We just upgraded to Solidworks from autocad14 about a month ago and I thought it would be a pretty fun project to draw one of these motors as a solid model, maybe even do an assembly if I can find all the other parts.
If anyone has knowledge of good prints existing somewhere and don't mind sharing that would be awesome. Even good front/side/top views without dimensions that I could scale would be great to start with.
At worst, and if I have time someday, I do have a spare block I could tear down and probably get a pretty decent result, but that will lot of work haha.
We just upgraded to Solidworks from autocad14 about a month ago and I thought it would be a pretty fun project to draw one of these motors as a solid model, maybe even do an assembly if I can find all the other parts.
If anyone has knowledge of good prints existing somewhere and don't mind sharing that would be awesome. Even good front/side/top views without dimensions that I could scale would be great to start with.
At worst, and if I have time someday, I do have a spare block I could tear down and probably get a pretty decent result, but that will lot of work haha.
#3
Sure, as I have time I am going to see what I come up with. It may be a long while before I have anything worth looking at though.
I did just spend 20 minutes or so grabbing some dimensions from my Clifford intake and drew this up so far. Still needs a lot of work obviously, but it is a start.
I did just spend 20 minutes or so grabbing some dimensions from my Clifford intake and drew this up so far. Still needs a lot of work obviously, but it is a start.
Thread
Thread Starter
Forum
Replies
Last Post
DougofMontana
1948 - 1956 F1, F100 & Larger F-Series Trucks
45
02-21-2014 10:16 PM