New Rotors rubbing dust shield
#1
New Rotors rubbing dust shield
Hey everyone,
I just replaced my parking brake dust shield, inner and outer bearings, hub seal, shoes and rotors- but the driver's side, the dust shield is fine, but the rotor rubs up against the brake shoes even though the star adjusment is at it's loosest.
Of note, there had been some previous work done on the driver's side rear end and when I went to put the parts back together there wasn't an oil slinger in place. It was there on the passenger side. My Ford dealer was closed and the auto parts store didn't have a part listed, so not sure if that may be part of the issue?
Thanks!
I just replaced my parking brake dust shield, inner and outer bearings, hub seal, shoes and rotors- but the driver's side, the dust shield is fine, but the rotor rubs up against the brake shoes even though the star adjusment is at it's loosest.
Of note, there had been some previous work done on the driver's side rear end and when I went to put the parts back together there wasn't an oil slinger in place. It was there on the passenger side. My Ford dealer was closed and the auto parts store didn't have a part listed, so not sure if that may be part of the issue?
Thanks!
#3
Thread
Thread Starter
Forum
Replies
Last Post