I'm an old school guy but this caught my eye and wondered if I might be swayed to use this system to wire my 52 F-1. Anyone used this method on their truck?
Tractorman Bill

 

I used an EzWire harness on my green truck. Using one from Speedway motors on my red 56 (save $50)..

Easy, well labeled, decent doc.

they group wires in sections, engine, lights, dash, rear.. I had to move a couple for my setup (brake lights assumed switch was in engine bay, not under dash like my setup)

Sam

 

I found mine easy to use and having never wired a vehicle before got the whole job done ok. Their instructions aren't the best in the world but could be worse.

 

Talked with them on wiring for an F-1 and they said front wiring from panel is 12 ft. and rear wiring is 22 ft. You cut off what you don't need and put your end on it.
Sounds like a screaming deal to me.
Tractorman Bill