Carb rebuild help!!! 1982 f100
#1
Carb rebuild help!!! 1982 f100
I'm about halfway finished rebuilding the carburetor on my f100, 300 straight 6. Problem is that there is a tiny ball bearing that is supposed to go somewhere, I think, but I can't figure for the life of me where it's supposed to go. The rebuild kit assembly page isn't any help at all. can anybody help me figure this out?
#2
#4
I just rebuilt my yfa last weekend. I used these videos to help me out. Carter YFA Carburetor Rebuild Part 1 of 4 - YouTube
Carter YFA Carburetor Rebuild Part 2 of 4 - YouTube
Carter YFA Carburetor Rebuild Part 3 of 4 - YouTube
Carter YFA Carburetor Rebuild Part 4 of 4 - YouTube
I found these videos very helpful. I had never torn apart a carb bigger than one on a honda generator motor before, and I got my YFA done no sweat. Even covers adjustments as well. This guy sells rebuild kits for all kinds of carburetors, too. Hope this helps.
Carter YFA Carburetor Rebuild Part 2 of 4 - YouTube
Carter YFA Carburetor Rebuild Part 3 of 4 - YouTube
Carter YFA Carburetor Rebuild Part 4 of 4 - YouTube
I found these videos very helpful. I had never torn apart a carb bigger than one on a honda generator motor before, and I got my YFA done no sweat. Even covers adjustments as well. This guy sells rebuild kits for all kinds of carburetors, too. Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
piddlar
1961 - 1966 F-100 & Larger F-Series Trucks
8
05-26-2004 08:31 AM
pramos
Fuel Injection, Carburetion & Fuel System
1
03-12-2003 11:17 AM