Does anybody know if they are the same thread? A buddy of mine made a hydraulic gauge setup for a 6.0 and wants to try it out on my truck. Just wanted to make sure they were same thread before I open a whole notha can of worms.

 

i think they are the same size, but %100 on it.

 

They take a #5 O-ring boss. I think that is 1/2 inch thread.

 

Great thanks!

 

Be careful and proceed gently. I used to think the updated ICP sensor was from the 6.0, but now I'm not sure. We've seen several ICP sensors from ebay with the wrong thread that requires an adapter to properly fit into our heads.

let us know what you figure out.