Couple of new mods planned
#1
Couple of new mods planned
Now that I have my truck fairly tuned well and no longer suffering through the lift, vibrations, etc I thought that now would be as best time as any to get some REAL gauges in the truck, go ahead and install the 4" MBRP (stainless) exhaust and also replace all the intercooler boots.
Boost Gauge. All the gauges all the same and I'm sure most of you have seen EV2 gauges before:
MBRP on the bottom and the box on the top is my new "A" pillar gauge holder:
Can't wait to get this stuff installed.
Have a great weekend everyone and a happy easter!
Boost Gauge. All the gauges all the same and I'm sure most of you have seen EV2 gauges before:
MBRP on the bottom and the box on the top is my new "A" pillar gauge holder:
Can't wait to get this stuff installed.
Have a great weekend everyone and a happy easter!
#2
ScanGauge Combo Kit : Linear Logic : Home of the ScanGauge I love REAL gauges, but it would have been lots less expensive to go with a Scan Gauge II.
#3
I have a scan gauge II in the truck and while it's great the boost reading is WAY off, not accurate and Exteemely slow updating since it uses the MAP sensor to read boost.
ScanGauge Combo Kit : Linear Logic : Home of the ScanGauge I love REAL gauges, but it would have been lots less expensive to go with a Scan Gauge II.
#4
Thread
Thread Starter
Forum
Replies
Last Post
ihateminimumwage
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
21
04-28-2018 05:34 PM