while im up and my moms im helping a budy do a injector install . what sizes is the nut on the injector not the 5/8 one the big one and my budy dint get a return line kit guys what size are the copper washers so i can run down to ace hard where and get a set and orings. and what are the trught specs

 

Its a 1 1/4 in deep socket to remove the injector, then the copper washers....i dont quiet remember....the torque is 35 ft lbs....

 

copper washers i am not sure but the injector is a 1" deep well socket

 

the ones you just gave me and the ones i took out where 1". It was the only socket i didn't have and had to buy a new one

 

easy peasy lemon squeezy. you will be fine. washers are small like 5.8 dia, 3/8 hole dia idr?

 

Just to agree with everyone else, you need a 1" deep well socket. The washers are not able to be easily found. I tried looking everywhere. I have a thread somewhere on here with the size of them.

 

1" deep well as everyone has said.

I got my coppper washers from the dealer. all 8 for ~$10. i don't think that was to bad since i new they were exactly what was needed.

 

Torque them to 45 ft/lbs. We have been around long enough to know 35 ft/lbs ain't enough for them. They usually leak with that little amount of torque.

 

mine are torqued to 35 ftlbs and they are sealing just fine.