Mustang II Power Steering Hose Question
#1
Mustang II Power Steering Hose Question
Charging the camera now so I can post pics but here's my question. My power rack from Heidt's has a threaded fitting opening and a 90 degree press in fitting that go into the box. I think I hooked them backward because on initial start up when I turned the wheel to the left full lock the press in fitting popped out of the hole in the box. Steering felt fine throughout. Of course that may be because the front end was up on jack stands without a load on the pump. Bottom line, is the press in fitting the low pressure return to the res.?
#2
#3
#4
Thread
Thread Starter
Forum
Replies
Last Post
rpol7966
1948 - 1956 F1, F100 & Larger F-Series Trucks
4
02-25-2010 11:36 AM
macintyremustang
1987 - 1996 F150 & Larger F-Series Trucks
2
04-15-2009 08:15 PM
65F100project
1961 - 1966 F-100 & Larger F-Series Trucks
7
10-02-2006 02:30 PM