Brake Line Fittings - 96 E350 Club Wagon
#1
Brake Line Fittings - 96 E350 Club Wagon
Hoping y’all can save me some frustration. Went and did new wheel cylinders and drum hardware on the rear of out 96 Club Wagon. The passenger side hardline has been previously reaplced, but the drivers side appears to be factory, and rusted to ****. Needless to say, it’s not sealing at the cylinder.
I’d like to replace it, local dealer couldn’t find a part number, so I’m assuming I’m making a new line. Would love an alternative if anyone has one, but it’s a work van, and we need it back on the road.
From the information I can find, the driver side wheel cylinder has a M10x1 thread. I can’t find anything about what the fitting at the tee is though.
Does anybody know the size of the fitting for the drivers side rear hardline at the tee? Can anyone confirm that it’s an M10x1 at the cylinder?
Many thanks.
I’d like to replace it, local dealer couldn’t find a part number, so I’m assuming I’m making a new line. Would love an alternative if anyone has one, but it’s a work van, and we need it back on the road.
From the information I can find, the driver side wheel cylinder has a M10x1 thread. I can’t find anything about what the fitting at the tee is though.
Does anybody know the size of the fitting for the drivers side rear hardline at the tee? Can anyone confirm that it’s an M10x1 at the cylinder?
Many thanks.
Thread
Thread Starter
Forum
Replies
Last Post
saauvenshine
1948 - 1956 F1, F100 & Larger F-Series Trucks
5
05-12-2015 12:23 AM
Jaaaaaaackman
1994.5 - 1997 7.3L Power Stroke Diesel
2
05-22-2011 02:54 PM