Mass air conversion and now no cruise (e4od)
#1
Mass air conversion and now no cruise (e4od)
New to the threads here but looking for insight on solving this problem. Put in dunne rite performance mass air conversion kit with baumann tranny controller. Drove the bronco down the road before the conversion to reasure everything in working order as it was. Since doing the conversion i have lost my cruise control features. Spoke with the guys at baumann and have confirmed with me the eec IV and cruise module are seperate from one another. connectors are all good,fuses good, module was working as far as i knew until after conversion. checked vacuum and theres no leaks hoses are solid. any light on this situation would be appreciated.
#2
#7
Trending Topics
#8
I'm not sure of you can with these truck or not but on my buddy's old jeep we gave little sprays of I believe it was ether in areas and when the truck revved up a bit then we narrowed down the area for the leak an sprayed in that area to get closer till we found it.
Not so sure of its a good idea or would work tho...
Not so sure of its a good idea or would work tho...
#10
Thread
Thread Starter
Forum
Replies
Last Post
david00f150
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
8
09-18-2006 12:34 AM
lightninglowe
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
03-18-2003 01:25 PM