I've found the general dimensions I need HERE
Stock 2005
F350 CC
4x4
Dually
But there is one dimension I need to be fully preparred to fit the truck I'm flying up to Louisville to pick up saturday into my garage (with 4" to spare :hehe
I need THIS dimension:







To know how much of my wall unit I need to remove to fit the front of the truck in. I'm thinking I need to remove the area in red...but I MAY have to go higher.











Would someone with a similar truck mind throwing a tape from the ground straight up to about where 12" or so up on the hood would be vertically?
Basically I'm trying to do THIS:

With the black being the wall and the red being the remainding wall unit.
LOVE to have the garage preparred to just drive it in saturday night.
Thanks in advance

 

While I know you asked for the measurement on an f-350 dually, I just measured my '05 250. At the top of the grill, it's just a little over 49". At approximately 12-14" back from the front of the hood, it's just a little over 53".

The measurements for a 350 DRW shouldn't be much different. Mine is stock height and has the upgraded front springs so it should be close.

 

Thanks! Parked in front of one in my exploder today...seemed a bit taller than that

 

I just measured my stock height F250 which i believe has snow plow prep package and i would be willing to bet it sits higher in front then your truck. Top of the grille is 52", about a foot into the hood is around 56 or so

 

A half foot in my dually's only around 49". However, at the moment it has a cubic yard of black dirt in it.

 

But also 2wd right?

 

Right, 2wd....