1948-1952 ford truck parts
#16
Category: Accessories
Price: $1
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): CRX & pre '92 Civic
#18
i dont, but give me a few dys and let me look. i have some stuff boxed up and will look and see. midwest early ford parts has new ones for 53-56 fords. classic haulers has the correct dome lens gasket for you. as far as i know, no one is reproducing it yet for the 48-50. also, go on hamb ( honky *** message board)website and register free and put out a request. this has been the best information site i have ever been on. hope
this helps,
mark
over the hill gang
purveyor of vintage hot rods
678-713-6220
cartersville,ga.
this helps,
mark
over the hill gang
purveyor of vintage hot rods
678-713-6220
cartersville,ga.
#21
I have a front bed panel that came out of a 49 f1. It will need some hammer work. It is at my grandfathers place at the moment so I cannot send pictures, but let me know if you want them.
#24
Okay, I found a set and measured them. They are about 38 1/2 inches long if you measure at the back of the running board (not the dogleg that goes around the fender) It is about 15 inches deep at the front and about 10 inches deep in the rear. The set I have does have the correct mounting brackets on them.
#25
Here are some more parts I need to get rid of.
All are from a 54 f250.
deluxe heater - complete
ash tray
glove box door
pedal assembly
steering column
electric wipers
transmission cover
cowl vent assembly
battery cover
Make me an offer on this stuff. It is still together in the cab so if you want the whole thing let me know.
All are from a 54 f250.
deluxe heater - complete
ash tray
glove box door
pedal assembly
steering column
electric wipers
transmission cover
cowl vent assembly
battery cover
Make me an offer on this stuff. It is still together in the cab so if you want the whole thing let me know.
#28
I'm interested in the 48-52 bench seat, and the deluxe heater. Can you send me some pics and price? lamar_wilson@hotmail.com
Thanks
Thanks