Help with rear u-joint conversion 63 econo
#1
Help with rear u-joint conversion 63 econo
I have a USAF 63 econo that I am performing a drivetrain swap on. I have been told that it is a DANA 20. Of course the ujoints are TINY and this is my problem. I cannot find a conversion joint and am wondering if I have any options other than a rear end swap. Is there a yoke swap I could perform?
the ujoint specs I would need are below.
<table style="width: 222px; height: 224px;" id="yiv1526206880bodyDrftID" class="yiv1526206880" border="0" cellpadding="0" cellspacing="0"> <tbody> <tr> <td style="FONT-FAMILY: arial; FONT-SIZE: 10pt" id="yiv1526206880drftMsgContent">2.5625" = 650.875mm spread
1" = 25.4mm cup
3.25" = 825.5mm spread
1 1/16 (1.0625") = 26.9875mm cup
</td></tr></tbody></table>
the ujoint specs I would need are below.
<table style="width: 222px; height: 224px;" id="yiv1526206880bodyDrftID" class="yiv1526206880" border="0" cellpadding="0" cellspacing="0"> <tbody> <tr> <td style="FONT-FAMILY: arial; FONT-SIZE: 10pt" id="yiv1526206880drftMsgContent">2.5625" = 650.875mm spread
1" = 25.4mm cup
3.25" = 825.5mm spread
1 1/16 (1.0625") = 26.9875mm cup
</td></tr></tbody></table>
#2
Thread
Thread Starter
Forum
Replies
Last Post
CPUNeck
1999 - 2003 7.3L Power Stroke Diesel
43
12-20-2020 10:13 AM