Well December 4 we are fixin on having a GTG to pull the engine out of our F550. It's a 6.0L Powerstroke. It needs a good bit of work but the goal for the day is to just get the engine out.

Anyone that's interested can post up here.
GTG is at 110 Barberry Rd East haven, CT

1: Pete
2:
3:
4:
5:

 

Ill make it to this 6.uhoh GTG! and ill finally get my money to Andy for the shirts

1: Pete
2: Miles (and father probably)
3:
4:
5:

 

I'm planning on being there.

1: Pete
2: Miles (and father probably)
3: Greg
4:
5:

 

1: Pete
2: Miles (and father probably)
3: Greg
4: Aaron
5:

 

1: Pete
2: Miles (and father probably)
3: Greg
4: Aaron
5: Josiah(most likely)

 

1: Pete
2: Miles (and father probably)
3: Greg
4: Josiah(most likely)
5:

aaron will be unable to attend. there has been a pain in the **** change of plans. depending on what time i have to leave town/come back i may be able to show up for a bit in the morning or later in the day, but the middle of the day is for sure a no go for me. waiting for a solid time frame still....

 

I will be there but not all day.
1: Pete
2: Miles (and father probably)
3: Greg
4: Josiah(most likely)
5: Andy

 

1: Pete
2: Miles (and father probably)
3: Greg
4: Josiah(most likely)
5: Andy
6: Aaron

plans changed again

 

What time Sat. morning guys?

 

I'm planning on getting there to light the fire around 8:30 is that early enough for everyone?

BTW, Aaron, there may be pizza available at some point in the day if you show up...

 

Are we doing this around a bonfire?

 

i know where pete has some pallet wood to burn

 

I might have my elder daughter on Saturday which would mean no wrenching for me but I would probably still try to stop in with her for a short visit. Will update once I know for sure.

 

Inside with a wood heater.

 

Ah, gotcha. So inside and 90+ degrees, haha. I will be showing up with a sleeveless shirt under my coat, haha.