Category: Accessories
Price: $125
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): '92+ Civic/EL & Del Sol, '06+ Civic/CSX, Prelude
Item Condition: AZ
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck

I was asked to bring this add back up... also it would be a good time to update it

I have sold the heck out of these seat brackets 65 and 66 cost of these are now $140.00 + shipping. these can be shipped via USPS for a flat rate of 20 bucks in the lower 48 states, every where else will be sent at actual cost of shipping.

67-72 seat bucket seat brackets have been redesigned to as close to the factory pieces and sell for $175.00 + shipping, these parts weigh more than 20 lbs and do not fit a flat rate USPS box so they must be sent via UPS at what ever it cost, most of them have shipped at around 30-40 bucks. i think it was around 25 to California. need a zip code for quote

Thanks All!

 

Would these work on a 59 thanks

 

no, the floor pan is completely different.... thanks for asking though.

 

Confirming these will work on a '65 F600 - I'm pretty sure the cab is the same as an F100. Please advise...

 

Danny, the 65 big trucks use the 61-64 cabs... with the step well just inside the door, the floor is not exactly the same. the brackets will work, but the seats will lean in towards each other, nothing a few extra washers under the seat tracks won't fix. if you have the cab without the steps, they will work perfectly.

 

Hey All... have 2 sets of 65-66 seat brackets ready to go, they are $150.00 + 18.00 bucks shipping via USPS flat rate. cashiers check price only, i can do paypal for the extra fee they will want.

Thanks Everyone

 

Hi bill,
Have any 66-72 brackets available? If so please PM me

 

I could use some brackets for the 1973-1979 floorpan. Any chance you still sell them??? Zip code is 89178.

 

Hi Paul, i sent you a PM. i have them in stock for the 67-72 73-79 floor pans

Thanks!

 

Bill,

I am interested in the 65-66 brackets. Could you send me a PM with the details of shipment and payment options?

Rg0472@bellsouth.net

Thanks,

Rickey

 

It's not clear to me in posts, but, what is the difference between 1966 Ranger brackets and 1967 and up brackets? The outsides look the same but what about the inners?

 

here is a photo of the 67-72 seat brackets... i will take a photo of the 65-66 brackets and post them later.

 

I found out the 67 outside brackets if used on the 66 will put the seats left of center of steering wheel about 2". So are the inside brackets the ones that are the same for all years?

 

Do you have any of the 73-79 brackets left?

 

65-66 brackets are different from 67-72... inner and outer brackets.
none are the same for all years.


not right now.