Category: Accessories Price: $125 Private or Vendor Listing: Private Listing Location (State): AZ Item Condition: Brand New Shipping Information: Item can be shipped Engine: Part suitable for gas truck Part fits:: 1961-1966, 1967-1972, 1973-1979
Good Day, Reproduction Ranger seat brackets are offered for sale at a very affordable price...almost half the cost of others offering them.
Laser cut and Professionally made in Tucson.
the brackets will allow you to install early mustang bucket seats in your 65-66 f100-250 and will work on the 67-72 f100-250, 73-79 f100-250 trucks as well. the floor pan is the same through all these years of trucks.
i would think you could use other bucket seats from maybe a comet or falcon as the early mustang was built off of that platform. but you would need to do some measuring to make sure!
the brackets are 125.00 + shipping cost. i will ship anywere in the USA and may be able to ship to other countrys as well.
I am set up to accept paypal. cashiers checks accepted, personal checks will need to clear before i ship for obvious reasons.
Please PM me if you would like a set of them. Thank You.
interested in a set of seat brackets for my 1966 f100. I live in Delta bc canada near vancouver. Very close to blaine washington might be cheaper to ship there and i can pick them up.
The floor of the cab is the same up to 79 so they will bolt right in, you need to check if the steering wheel is 15 inches over.... a slick(65-66) steering wheel is 16 inches over. Bump steering wheel is 15 inches over. (over), meaning from the left side of where the dash starts to the center of the column.
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. Ford® is a registered trademark of the Ford Motor Company.