Porting heads /460 / specifications?
#1
11-09-2010, 11:17 AM
Join Date: Jun 2007
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
Porting heads /460 / specifications?
I am pulling the heads off my 75 460 to having them rebuilt. Along with this, they will be porting the exhaust - it is my understanding that this is recommended to eliminate the restricted exhaust flow.
I will be install hedman 89140 headers after the heads are finished. When they port the heads, would I want/need to give them any specifications for the headers to match the opening size or does this not make any difference?
I will be install hedman 89140 headers after the heads are finished. When they port the heads, would I want/need to give them any specifications for the headers to match the opening size or does this not make any difference?
#2
11-10-2010, 08:14 AM
Might want to look into something like these as a swap in replacement.
There's far more potential than the first gen emissions heads you have now.
RHPD3Index
There's far more potential than the first gen emissions heads you have now.
RHPD3Index
Thread
Thread Starter
Forum
Replies
Last Post
cjben
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
3
09-09-2008 11:47 PM
buffalobob
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
1
10-14-2007 12:47 PM
460man
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
2
01-20-2007 08:08 PM
