How to replace the backlight bulb in a 1992 Ford DIN style radio.
By Patrick Fogle
- #1 Phillips Screwdriver
- Needle nose pliers
- 1 #37 bulb
Turn all controls to one side or the other, make them all the same for easier reassembly (as seen above).
Pull the knobs off, this may require some effort.
Remove screws that hold the face on. Highlighted in red
Gently remove the face. This can be tricky, so be careful not to break any wires. Again the bulb is highlighted in red.
Step 5: Use the pliers to replace the bulb. Be gentle it is glass. I have found it is possible to do it without breaking the bulb.