Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 3)  

Test Fitting the EGR to the Adapter After the fitting were test fitted we clamped the EGR valve to the adapter to measure/mark where the holes in the EGR valve were on the adapter. We then drilled two holes through the adapter big enough to allow a 5/16 bolt to run through so can can connect the adapter to the EGR valve. We found that a 4" piece of aluminum would have made life easier but this aluminum was free so we can't complain too much. It just mean we had to be careful how close to the edge we drilled the holes to the edge of the aluminum block. Page Four

Email    Print    Add Comment

Related Articles

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 2) Tapping the aluminum blockTapping the holes wasn't exactly rocket...   8-3-2004

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 1) By Mark Strickland Custom Fabrication of an EGR system for a Ford 300...   8-3-2004

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 4) Finished EGR This is where the instructions really end. Once you have...   8-3-2004

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 5) Close up of the EGR/O2 fittingThis is a close up of the EGR line being...   8-3-2004

User Comments

Add Comment

No comments have been posted.